Mercedes S-class W202

1993-2000 of release

Repair and car operation

Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
- 9. Transmission
   + 9.1.2. Check of a thickness of a disk of coupling in the mounted condition
   - 9.2. Mechanical and automatic boxes of a gear change
      + 9.2.2. A transmission
      9.2.3. Towage of the cars equipped with the automatic machine
      9.2.4. Check of level of oil in an automatic transmission
      9.2.5. Transmissionnoe oil and the filter
      9.2.6. A cable of operating pressure
      9.2.7. A switching rod
      9.2.8. "Automatic machine"
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes

9.2.5. Transmissionnoe oil and the filter

трансмиссионного oils usually change refuelling through each 60 000 km of run of the car, simultaneously also replace also the filter. At operation severe conditions (work with the trailer, trips mainly on short distances and movement in cities, extremely heat of external air) it is necessary to change трансмиссионное oil through each 30 000 km of run (without filter replacement).

The prevention

Hand over fulfilled трансмиссионное oil on special points of gathering of the fulfilled oils, in no event simply do not pour out it and do not mix with household dust.


1. Establish the lever of a selective choice in position "Р".
2. Поддомкратьте the car in horizontal position.
3. If necessary remove the bottom cover of a motor compartment.
4. Establish under a transmission маслосборник (suitable capacity).
5. Unscrew in the oil pallet (3) carving stopper of a drain aperture (1) and merge oil.
6. Turn a pulley of a cranked shaft of the engine in a direction of rotation of its shaft (assistant) until the carving stopper of a drain aperture on the twisting moment converter will not be established over an aperture of a ventilating lattice. Turn an engine shaft.
7. Turn out a carving stopper (2) drain apertures and merge oil.
8. Unscrew bolts (7) oil pallets (3).
9. Unscrew bolts (6) oil filters (5), remove it downwards.
10. Screw the new oil filter with the moment nearby 4 Н.м.
11. Carefully clear the oil pallet and spread new consolidation.
The prevention

To clearing apply only pure, not fleecy rags and pay attention on идеальнейшую cleanliness at carrying out of all working operations.

12. In regular intervals hardly tighten fixing bolts to the oil pallet with the moment 8 Н.м.
13. Screw in carving stoppers of drain apertures with new sealing rings and hardly tighten them with the moment 8 Н.м.
14. Lower the car.


1. Tighten a lay brake.
2. Open the lever замкового devices and on the index of level of oil, extend the index and at the idle engine fill in 4 litres трансмиссионного oils ATF through a pure funnel and a sieve with small cells.
3. Start the engine and leave it to work in an idling mode.
4. Add the remained quantity трансмиссионного oils ATF. Check up level of oil by means of the index.
5. Filled quantity:
The 4-cylinder engine: about 5,5 l;
The 6-cylinder engine: about 6,0 l
6. At the standing car switch in all positions the lever of a selective choice, thus the lever leave accordingly for some seconds in separate positions. Then again establish the lever in position "Р".
The prevention

At switching of ranges of change of the transfer relation in addition press a foot brake.

7. Insert against the stop the index of level and block its lever замкового devices.
8. Spend a short-term trial trip, thanks to it трансмиссионное oil will get working temperature 80 With.
9. Establish the car on an equal surface.
10. Check up level трансмиссионного oils at frequency of rotation of a shaft of the engine in an idling mode, if necessary, add oils.
11. Visually check up tightness of carving stoppers of drain apertures and the oil pallet.
12. Establish the bottom cover of a motor compartment.