Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
- 9. Transmission
   - 9.1.2. Check of a thickness of a disk of coupling in the mounted condition
      9.1.3. Coupling check
      9.1.4. The bearing муфты coupling deenergizings
      9.1.5. Removal of air from a control system of coupling
      9.1.6. Пробуксовочка
      9.1.7. Diagnostics of malfunctions of system of coupling
   + 9.2. Mechanical and automatic boxes of a gear change
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







9.1.4. The bearing муфты coupling deenergizings
THE GENERAL DATA

Noise of the working bearing in the switched off condition, that is, at the squeezed out pedal of coupling, specifies in malfunction of the bearing муфты coupling deenergizings.

Removal

PERFORMANCE ORDER
1. Remove a transmission.
2. Remove the bearing муфты deenergizings of coupling (1) from a tubular support on a forward cover of a transmission.
3. Move a plug of deenergizing of coupling (2) in an arrow direction () and then remove in an arrow direction () from a bolt with a spherical head (3) on картере couplings and remove it.

Check

PERFORMANCE ORDER
1. Compress and simultaneously rotate the bearing муфты coupling deenergizings.
2. If the bearing rotates spasmodically, establish the new bearing.
3. Check up sliding surfaces on absence of deterioration, corrosion and damages.

Installation

PERFORMANCE ORDER
1. Wipe a pure rag of a surface of the bearing and contact surfaces and grease them МОS2 – plastic дисульфидмолибденовой with greasing.
The prevention

Put not enough greasing that in the mounted condition greasing could not get on a friction surface.


2. Squeeze out the bearing муфты deenergizings of coupling (2) against a direction () on a bolt with a spherical head (3) until it will be fixed скоба for fastening of a spring of a plug. Then move a plug against an arrow direction () until press the core of the distributive cylinder will not adjoin a flute of a plug of deenergizing of coupling.
3. Grease inside the bearing муфты deenergizings of coupling and both lateral dredging on a back part муфты.
4. Spread the bearing муфты coupling deenergizings on a tubular support and turn it until it will not get to lateral grooves in a plug.
5. Mount a transmission.