Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
- 8. Fuel system
- 8.1.1. Introduction
8.1.2. A fuel tank
8.1.3. The gauge of level of fuel
8.1.4. The fuel pump
8.1.5. The fuel filter
8.1.6. The air filter
8.1.7. A cross-section pipe of the air filter
8.1.8. An inlet gas pipeline
8.1.9. A cable of gas / the lever throttle заслонки (DB)
8.1.10. A cable of management of gas (DB)
8.1.11. A contour of fuel of the diesel engine
8.1.12. Prestarting heating of diesel fuel
8.1.13. The fuel thermostat
8.1.14. The hydrovalve case
8.1.15. A cable of gas / the lever throttle заслонки (ДД)
8.1.16. A cable of management of gas (ДД)
+ 8.2. System of injection of petrol engines
+ 8.3. System of injection and a food of diesel engines
+ 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes
|
THE PETROL ENGINE
Removal
| PERFORMANCE ORDER |
| 1. Extend a temperature-sensitive element for let in air (В17) from a cross-section pipe, for this purpose compress keeping clips (arrow). |
| 2. Screw collars (4/8), (4/13) and remove a cross-section pipe of the air filter (4/5) together with a shaped hose (4/6). |
|
Installation
| PERFORMANCE ORDER |
|
|
1. The 4-cylinder engine: a cross-section pipe of the air filter насаживайте so that both basing elements on the bottom party were squeezed in keeping ledges on a casing of wires of a high voltage (arrow). |
| 2. The 6-cylinder engine: a cross-section pipe of the air filter насаживайте so that the welded on hollow pins were pressed into rubber support of a cover of a head of the block of cylinders. Hollow pins serve for ventilation картера the engine and for fixation of a cross-section pipe. |
| 3. Hardly tighten шланговые collars. |
| 4. Establish a temperature-sensitive element for let in air (1В17) and squeeze out outside keeping clips until they will not be fixed with click. |
|
THE DIESEL ENGINE
Removal
| PERFORMANCE ORDER |
| 1. Unscrew bolts (97/3) on an inlet gas pipeline. |
| 2. Unscrew bolts (97/2) from the holder (97/1) cross-section pipes of the air filter. |
| 3. Remove a cross-section pipe of the air filter. |
|
Installation
| PERFORMANCE ORDER |
| 1. Check up on defects and porosity condensing манжетку (97/4) and sealing rings of a round profile on the hydrovalve case / to a cross-section pipe of the air filter, if necessary replace. |
| 2. Insert a cross-section pipe of the air filter, establish bolts in an inlet gas pipeline. |
| 3. Screw the holder and tighten to the full bolts on an inlet gas pipeline. |
|
|
|