Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
- 8. Fuel system
- 8.1.1. Introduction
8.1.2. A fuel tank
8.1.3. The gauge of level of fuel
8.1.4. The fuel pump
8.1.5. The fuel filter
8.1.6. The air filter
8.1.7. A cross-section pipe of the air filter
8.1.8. An inlet gas pipeline
8.1.9. A cable of gas / the lever throttle заслонки (DB)
8.1.10. A cable of management of gas (DB)
8.1.11. A contour of fuel of the diesel engine
8.1.12. Prestarting heating of diesel fuel
8.1.13. The fuel thermostat
8.1.14. The hydrovalve case
8.1.15. A cable of gas / the lever throttle заслонки (ДД)
8.1.16. A cable of management of gas (ДД)
+ 8.2. System of injection of petrol engines
+ 8.3. System of injection and a food of diesel engines
+ 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes
|
THE PETROL ENGINE
Removal
PERFORMANCE ORDER |
1. The engine in volume of 1,8 and 2,0 l: ослабьте a collar (4/8) also remove from the air filter (4) air hose. |
2. Engines in volume of 2,2 and 2,8 l: remove from the air filter (4) flowmeter together with an air hose, preliminary having opened a fastening collar on a branch pipe of the air filter. Check up on absence of damages a sealing ring of round section. |
3. Remove the inlet pipeline (4/16). |
4. Extend the air filter from rubber support (marksman) and remove it. |
|
Installation
PERFORMANCE ORDER |
1. The air filter with keeping ledges insert into rubber support (arrow). Spread the inlet pipeline (4/16). |
2. Engines in volume of 1,8 and 2,0 l: spread on the air filter an air hose and fix its collar. |
3. Engines in volume of 2,2 and 2,8 l: insert a flowmeter with a sealing ring of round section and fix its collar of fastening. |
|
THE DIESEL ENGINE
Removal
PERFORMANCE ORDER |
1. Remove a spring of a clip from a hose going from a compensatory tank with the cooling liquid to the air filter. |
2. Remove an air hose from the air filter, preliminary having weakened and having shifted back a collar. |
3. Remove soaking up air inlet. |
4. Take from rubber support the air filter and remove it. |
|
Installation
PERFORMANCE ORDER |
1. Insert into rubber support the air filter together with directing pins. |
2. Spread soaking up air inlet. |
3. Pull over the air filter the air hose going from a compensatory tank with the cooling liquid to the air filter. |
|
|
|