Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
- 8. Fuel system
   - 8.1.1. Introduction
      8.1.2. A fuel tank
      8.1.3. The gauge of level of fuel
      8.1.4. The fuel pump
      8.1.5. The fuel filter
      8.1.6. The air filter
      8.1.7. A cross-section pipe of the air filter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas / the lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas / the lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. System of injection of petrol engines
   + 8.3. System of injection and a food of diesel engines
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







8.1.14. The hydrovalve case
THE GENERAL DATA

The order of performance of works on the diesel engine is more low stated.

Removal


PERFORMANCE ORDER
1. Ослабьте on an air hose a collar (90/1).
2. Remove a vacuum hose (100а) with мембранного the mechanism of a vacuum advancing of ignition of the hydrovalve (100).
3. Unhook connecting draught (200) on the hydrovalve.
4. Unscrew two bolts (60/2) and displace aside the system valve рециркуляции the fulfilled gases (60).
5. Unscrew three bolts (105/1).
6. Extend the hydrovalve case (105а) from a cross-section pipe of the air filter.

Installation

PERFORMANCE ORDER
1. Check up on damage a sealing ring of a round profile, if necessary replace it.
2. Push in a cross-section pipe of the air filter the hydrovalve case together with sealing rings of a round profile. For this purpose ослабьте bolts of the holder of a cross-section pipe of the air filter and then again tighten.
3. Screw the hydrovalve case.
4. Screw the system valve рециркуляции the fulfilled gases.
5. Hang connecting draught on the hydrovalve.
6. Spread a vacuum hose.
7. Spread an air hose and fix its collar.