Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
- 8. Fuel system
   - 8.1.1. Introduction
      8.1.2. A fuel tank
      8.1.3. The gauge of level of fuel
      8.1.4. The fuel pump
      8.1.5. The fuel filter
      8.1.6. The air filter
      8.1.7. A cross-section pipe of the air filter
      8.1.8. An inlet gas pipeline
      8.1.9. A cable of gas / the lever throttle заслонки (DB)
      8.1.10. A cable of management of gas (DB)
      8.1.11. A contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. The fuel thermostat
      8.1.14. The hydrovalve case
      8.1.15. A cable of gas / the lever throttle заслонки (ДД)
      8.1.16. A cable of management of gas (ДД)
   + 8.2. System of injection of petrol engines
   + 8.3. System of injection and a food of diesel engines
   + 8.4. System of release of the fulfilled gases
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







8.1.10. A cable of management of gas (DB)
THE GENERAL DATA

THE PETROL ENGINE


The prevention

The cable of management of gas is very sensitive to bends and consequently at installation with it it is necessary to address especially cautiously. The unique easy bend can lead subsequently to its breakage at car operation. Therefore the bent cables should not be used at installation.


Removal


PERFORMANCE ORDER
1. Remove directing element (30/5). Thus at first extend from it a plastic nipple.
2. Unhook a cable (30) managements of gas. For this purpose deduce through a cut in кулисном the lever (32/6) тросовый a drive. Compress a plastic spring clip (30/4) and extend a cable on a support (32/3).
3. Remove a protective casing under the control panel.
4. Unhook fastening тросового a drive on the accelerator lever. For this purpose extend the holder with распорным a bolt.
5. Squeeze out outside of internal space of the car a gas cable. Thus do not put forward the rubber plug.
6. In the complete set remove a gas cable.

Installation

PERFORMANCE ORDER
1. Grease with anticorrosive greasing Mercedes-000 989 87 5110 cable of gas between a directing element and a tip.
2. Check up the rubber plug on absence of damages and porosity, otherwise replace.
3. Stretch in internal space of the car a cable of management of gas and hang it on the lever of a pedal of an accelerator.
4. Mount a protective casing under the control panel.
5. Enter through an aperture in a support a cable of management of gas, press it into a support and fix.
6. Hang together with a directing element a cable of management of gas. Pay attention to that the plastic nipple has been fixed in a directing element.
7. Adjust a cable of management of gas.