Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
- 2. Maintenance service
   + 2.1.1. The engine
   2.2. In addition through each 60 000 km of run
   2.3. Every 2 year
   2.4. Every 3-4 year
   + 2.5. Works on maintenance service
   + 2.6. Care of the car
   2.7. Start of the engine from the auxiliary accumulator
   2.8. Car towage
   2.9. Car lifting
   2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes











2.9. Car lifting
THE GENERAL DATA

Lifting and support points: an onboard automobile jack


The car lift in a workshop


The automobile lift with a platform, подставные goats and the car lift in a workshop


The prevention

At work under the car if there is no automobile lift with a platform, establish it on two or four steady goats. At all do not work under the car if he is insufficiently insured or if it is propped up only by an automobile jack. It is life-threatening!

Raise the car only in not loaded condition.

Using a rubber or wooden lining, it is possible to avoid at lifting of the car of damage of the basis of its body. In no event it is impossible to raise or prop up the car under the engine or under a transmission.

Fix wedges wheels standing on a basic surface against them скатывания forward or back. Do not rely on lay brake system as at some repair work it should be расторможена.

Lift the car only on an equal rigid surface.

The car put on подставные goats so that accordingly one his foot sideways stuck out outside.


Operating with a screw-driver as the lever, remove a protective casing on a landing aperture for an automobile jack.

Cautiously insert an adjusting finger of an automobile jack into a plug-in pipe of a longeron.

Establish an automobile jack vertically even at a bias.

Raise the forward bridge ahead, having established the lift on a cross-beam of a frame (6) (fig. the car Lift in a workshop see).

Raise the car behind, having established the lift on крестовине the back bridge (fig. the car Lift in a workshop see).

Reference points ahead and behind are below plug-in pipes for an onboard automobile jack and are supplied эбонитовыми by shock-absorbers (fig. the Automobile lift with a platform, подставные goats and the car lift in a workshop see).


The prevention

Points of support on longerons can be used and for lateral lifting with use of the lift of the car in a workshop. Thus establish an automobile jack under эбонитовыми shock-absorbers.