Mercedes S-class W202
1993-2000 of release
Repair and car operation
+ 1.2. The general data
- 2. Maintenance service
+ 2.1.1. The engine
2.2. In addition through each 60 000 km of run
2.3. Every 2 year
2.4. Every 3-4 year
+ 2.5. Works on maintenance service
+ 2.6. Care of the car
2.7. Start of the engine from the auxiliary accumulator
2.8. Car towage
2.9. Car lifting
2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes
If it is inexact the ordered recommendations about connection are observed, there is a danger of reception of burns because of the spilt electrolit which basis is made by sulfuric acid. Besides, it is possible to be traumatised or bruises because of explosion of the storage battery, or there can be malfunctions in an electric equipment.
The cross-section section of a wire for starter connection to the auxiliary storage battery should make not less than 16 sq. mm (diameter about 5 mm) for internal combustion engines with compulsory spark ignition of a working mix up to volume of cylinders of 2,5 l. At engines with volume of cylinders over 2,5 l and at diesel engines the cross-section section of this wire should make at least 25 sq. mm. Thus defining is, naturally, the car with the discharged storage battery. As a rule, the cross-section section of a wire is specified on its packing. It is recommended to get this wire with the isolated tightening grips and cross-section section 25 in sq. mm as it approaches and for engines with rather lower working volume of cylinders.
Both storage batteries should have pressure of 12 Volt.
The discharged storage battery can already freeze at temperature–10 ° S.Pered connection of a wire for starter connection to auxiliary (out of the car) the storage battery the frozen storage battery necessarily defreeze.
The discharged storage battery should be correctly connected to an electric onboard network.
Check up liquid level in the discharged battery. If necessary add the distilled water.
Establish cars on such distance among themselves that between them there was no metal contact. Otherwise at connection of a positive pole the current can already proceed.
At each of two cars tighten the manual lever of lay brake system. Establish a step transmission in neutral position, and in case of an automatic transmission – in parking position "Р".
Disconnect all consumers of a current.
Necessarily the engine of the auxiliary car should work during process of start-up of the basic car with frequency of rotation in an idling mode. Thanks to it possibility of damage of the generator because of the peaks of pressure arising at start-up is excluded.
During start-up avoid occurrence of an open flame and burning cigarettes near to the storage battery because from it combustible gases can be allocated.
Pay attention to that wires for starter connection to the auxiliary battery could not be damaged rotating details, such, as the fan of system of cooling of the engine.
Connect wires for starter connection to the auxiliary storage battery as follows:
1. A red wire connect to the plug of a positive pole of the discharged accumulator room of the battery ().
2. Other end of a red wire attach to the plug of a positive pole of the storage battery giving a current ().
3. A black wire attach to the plug of a negative pole of the storage battery giving a current.
4. Other end of a black wire connect to a good point of the case () the reception car. Is better for this purpose the metal detail screwed on the block of cylinders of the engine approaches. Under adverse circumstances: at wire connection to a negative pole of the discharged battery last can blow up because of искрообразования and detonating gas allocation.
Plugs of wires for starter connection to the auxiliary storage battery at the connected wires should not contact among themselves, or positive plugs should not adjoin to the case (a body or a frame).
Start and leave to work the engine of the reception car (the storage battery is discharged). At start continuously press a starter not longer 10 seconds as because of high consumption of a current tightening grips of poles and a wire heat up. Therefore sometimes maintain "a cooling pause" not less than 1/2 minutes.
Do not bend over storage batteries – there is a danger травмирования!
After engine start-up disconnect clips from plugs in return sequence: at first disconnect from the plug a black wire (–) on the reception car, and then – on the car submitting a current, at first disconnect from the plug a red wire on the car submitting a current, and then – on the reception car.