Mercedes S-class W202
1993-2000 of release
Repair and car operation
+ 1.2. The general data
- 2. Maintenance service
+ 2.1.1. The engine
2.2. In addition through each 60 000 km of run
2.3. Every 2 year
2.4. Every 3-4 year
+ 2.5. Works on maintenance service
- 2.6. Care of the car
2.6.2. Care of the painted surfaces
2.6.3. Care of plastic details
2.6.4. Care of glasses and rubber consolidations
2.6.5. Care легкосплавными disks
2.6.6. Seat belts
2.6.7. Anticorrosive protection
2.6.8. Preservation of a motor compartment
2.6.9. Care of an upholstery of armchairs
2.7. Start of the engine from the auxiliary accumulator
2.8. Car towage
2.9. Car lifting
2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes
To thicket, than it is required, purely washed up and dried up varnished surfaces for protection against influence of weather conditions process preserving means for creation closing a time and a water-repellent wax layer.
Immediately delete the poured fuel, oil or the greasing, especially poured brake liquid, differently it leads to change of colouring of a varnish covering.
Preservation repeat when the varnish any more does not push away water and it spreads on the big area. Regular preservation promotes preservation for a long time initial shine of a varnish covering.
Additional possibility for preservation of varnish coverings is given by application of washing preservatives which sufficiently protect a varnish covering only in the event that they are applied at each sink of the car, and the time interval between two sinks makes no more than two-three weeks. Apply only such varnish preservatives which contain карнаубский or synthetic wax.
After application of washing-up liquids (a sink foam) especially it is necessary to recommend the subsequent processing with preservative application (pay attention to the instruction on application).
Polishing of varnish coverings spend only in the event that the varnished covering because of insufficient leaving, under the influence of a road dust, industrial departing gases, the sun and a rain became unattractive, and shine cannot be restored by means of preservatives any more.
It is necessary to warn against application of abrasive or chemically aggressive polishing means even if the first attempt of use has appeared enough successful.
Before each polishing the car should be washed purely up and dried carefully up. In the rest it is necessary to arrive according to the instruction of polishing means.
It is not necessary to process too big surfaces to avoid premature drying of polish. At application of some polishing means it is necessary to make preservation in addition. Do not make polishing on a shining sun! Do not process preservatives or polishing means матоволакированные a detail.
Removal of stains of tea
Tea stains during short time eat into a varnish covering, and they then cannot be removed completely. Fresh stains from tea can be removed the soft rag moistened in washing gasoline. In a special emergency it is possible to apply gasoline from бензораздаточной columns, kerosene or терпентиновое oil. Very well for removal of stains from tea varnish preservative approaches also. After application of this means it is possible to refuse the subsequent sink.
Removal of insects
Remains of insects contain substances which can damage a varnish film if them at once not to remove. For removal it is necessary to wash off their weak tepid soap solution or a washing-up liquid solution. There is also a special means for removal of insects from a surface of varnish coverings.
Removal of splashes of building materials
Splashes of building materials wash off a tepid solution of a neutral washing-up liquid. Only slightly wipe, differently it is possible to scratch a varnish covering. After washing carefully rinse a surface pure water.