Mercedes S-class W202
1993-2000 of release
Repair and car operation
+ 1.2. The general data
- 2. Maintenance service
+ 2.1.1. The engine
2.2. In addition through each 60 000 km of run
2.3. Every 2 year
2.4. Every 3-4 year
+ 2.5. Works on maintenance service
- 2.6. Care of the car
2.6.2. Care of the painted surfaces
2.6.3. Care of plastic details
2.6.4. Care of glasses and rubber consolidations
2.6.5. Care легкосплавными disks
2.6.6. Seat belts
2.6.7. Anticorrosive protection
2.6.8. Preservation of a motor compartment
2.6.9. Care of an upholstery of armchairs
2.7. Start of the engine from the auxiliary accumulator
2.8. Car towage
2.9. Car lifting
2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes
Whenever possible urgently помойте the polluted car.
Before a car sink presoak remains of dead insects and смойте them.
Plentifully use water.
Apply a soft sponge or very soft washing brush with hose connection.
Not strongly wash out a water stream the places covered with a varnish but only water with a per capita stream of water, a dirt leave размокать.
Razmokshuju dirt wash off from top to down water enough.
Often rinse a sponge.
To drying apply a pure skin.
Apply only a good, fat-free firm washing-up liquid (if is available). Necessarily in addition wash off the washing-up liquid rests.
For varnishing protection it is possible to water for a sink to add washing preservatives.
At regular use of washing-up liquids it is necessary to make preservation is more often.
Never wash and do not dry the car on the sun. Otherwise it is inevitable on varnishing there are water stains.
To all located in grooves, flanges and joints in the doorway and casings (covers) salts for посыпки streets are especially dangerous. Therefore after each sink of the car, even after a sink on the automatic transfer line, it is necessary to clear these places necessarily a sponge, then to rinse and dry up a skin.
After a sink of the car because of a moisture brake action decreases. Therefore quickly make braking before drying of disks of brake mechanisms.