Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
- 2. Maintenance service
   + 2.1.1. The engine
   2.2. In addition through each 60 000 km of run
   2.3. Every 2 year
   2.4. Every 3-4 year
   - 2.5. Works on maintenance service
      + 2.5.1. The engine and system of release of the fulfilled gases
      + 2.5.2. A box predach/the main transfer
      + 2.5.3. The forward bridge / a steering
      - 2.5.4. Tyre Brakes /
         2.5.4.1. Check of a thickness of frictional overlays brake колодок
         2.5.4.2. Check of level of a brake liquid
         2.5.4.3. Check of an alarm lantern of level of a brake liquid
         2.5.4.4. Visual check of pipelines of a brake drive
         2.5.4.5. Replacement of a brake liquid
         2.5.4.6. Check of drawing of a protector of a tyre cover (tyre)
         2.5.4.7. Check of the gate of the pneumatic chamber or the tyre
         2.5.4.8. Pressure check in beefy tyres
      + 2.5.5. The Body / internal illumination
   + 2.6. Care of the car
   2.7. Start of the engine from the auxiliary accumulator
   2.8. Car towage
   2.9. Car lifting
   2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







2.5.4.1. Check of a thickness of frictional overlays brake колодок
PERFORMANCE ORDER
1. Note a paint position of wheels in relation to their naves. Thanks to it отбалансированное the wheel can be established again in a former position. Ослабьте wheel bolts at the car standing on a basic surface. Преподнимите the car also remove wheels.
2. Check up a thickness of brake disks.
3. Measure a thickness of frictional overlays brake колодок (without a back plate) by means of a calliper. The limit of deterioration of frictional overlays of disk brakes on the forward and back bridge is reached in the event that the frictional overlay without a back plate has a thickness only 2 mm. In this case always change all four frictional overlays of one bridge.

The prevention

According to a simple rule, at forward disk brakes of a frictional brake overlay of 1 mm corresponds to run at least in 1000 km. This rule is valid even at car operation under adverse conditions. In a normal case frictional overlays maintain much more. At a thickness of frictional overlays of disk brakes in 5,0 mm (without a back plate) residual suitability of frictional overlays brake колодок, hence, still makes at least 3000 km of run.


4. Spread wheels so that the marks put at dismantling have coincided. Preliminary slightly grease with plastic greasing for bearings качения aligning nest of a rim on a wheel nave. Screw wheels. The car lower and hardly crosswise tighten wheel bolts with the moment 110 Н.м.