Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
- 2. Maintenance service
   + 2.1.1. The engine
   2.2. In addition through each 60 000 km of run
   2.3. Every 2 year
   2.4. Every 3-4 year
   - 2.5. Works on maintenance service
      + 2.5.1. The engine and system of release of the fulfilled gases
      + 2.5.2. A box predach/the main transfer
      - 2.5.3. The forward bridge / a steering
         2.5.3.1. Check of hinges of the forward bridge
         2.5.3.2. Check of a free wheeling of a steering wheel
         2.5.3.3. Pulling up of fixing bolts on the steering mechanism
         2.5.3.4. Check of level of oil
      + 2.5.4. Tyre Brakes /
      + 2.5.5. The Body / internal illumination
   + 2.6. Care of the car
   2.7. Start of the engine from the auxiliary accumulator
   2.8. Car towage
   2.9. Car lifting
   2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







2.5.3.1. Check of hinges of the forward bridge
PERFORMANCE ORDER
1. Преподнимите in front the car.
2. Shine at the left and on the right with a lamp dustproof caps of the axial hinge (7) and check up them on absence of damages, thus pay attention to greasing traces on cuffs and round them.
3. Shine at the left and on the right with a lamp dustproof caps of the directing hinge and check up them on absence of damages, thus pay attention to oil traces on cuffs and round them.
4. At damage of a dustproof cap, with a view of safety replace the corresponding hinge together with a dustproof cap. The pronikshaja dirt for certain destroys the hinge.
5. Check up люфт the directing hinge of the top cross-section lever of a suspension bracket (6). For this purpose with force pull and press a forward wheel and simultaneously feel a finger the ball hinge. If люфт is available, replace the top cross-section lever of a suspension bracket.

The prevention

At carrying out of this test the hinge should be unloaded (the car поддомкрачен).


6. Check up a backlash of the axial hinge (7). For this purpose press from below (marksman) in a direction of the cross-section lever of a suspension bracket (4).
7. To stock-taking люфта in a repair truck apply the special tool. If люфт is available, replace the simple hinge.
8. Check up rigidity of landing of fixing nuts of simple and directing hinges, but thus do not turn them.