Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
- 2. Maintenance service
   + 2.1.1. The engine
   2.2. In addition through each 60 000 km of run
   2.3. Every 2 year
   2.4. Every 3-4 year
   - 2.5. Works on maintenance service
      - 2.5.1. The engine and system of release of the fulfilled gases
         + 2.5.1.1. Engine oil replacement
         2.5.1.2. Condition check клинового a belt
         2.5.1.3. Replacement of spark plugs
         2.5.1.4. Check of electric connections
         2.5.1.5. Greasing of a control system throttle заслонкой
         + 2.5.1.6. Check of level of a cooling liquid
         2.5.1.7. The conditioner: check of level of a coolant
         2.5.1.8. Replacement of the fuel filter / of the filter of rough clearing
         2.5.1.9. Replacement of a replaceable element воздушкого the filter
         2.5.1.10. Check of system of release of the fulfilled gases
      + 2.5.2. A box predach/the main transfer
      + 2.5.3. The forward bridge / a steering
      + 2.5.4. Tyre Brakes /
      + 2.5.5. The Body / internal illumination
   + 2.6. Care of the car
   2.7. Start of the engine from the auxiliary accumulator
   2.8. Car towage
   2.9. Car lifting
   2.10. The tools applied to maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







2.5.1.7. The conditioner: check of level of a coolant
THE GENERAL DATA

The prevention

It is impossible to open a circulating contour of a coolant in the conditioner. The coolant contains substances which in contact to a skin can lead обморожению.


PERFORMANCE ORDER
1. Clear the index of level (marksman) on a tank with a liquid.
2. Remove штеккерный a socket from a temperature-sensitive element (cooling means / air-conditioning) (В10/8). Зашунтируйте connections by an auxiliary wire.
3. Start the engine and leave it to idle.
4. Include the conditioner and establish it in position "Defrosting" or "Drying by air".
5. Remove a crosspiece on штекерном a socket and thus observe through an eye on a tank with a coolant. Quickly after inclusion electromagnetic connecting муфты the coolant should rise and then proceed without vials. In this case the coolant can be not visible any more.
6. Pull over a temperature-sensitive element штеккерный a socket.

The prevention

At more heats of environment (from above +35 ) even at normal quantity of a filling coolant there can be a foam and a few vials. At leak of a coolant or assumed негерметичности systems can be defined correct quantity of a filling coolant only by full опорожнения and new filling of system (work in a repair truck).