|
Mercedes S-class W2021993-2000 of releaseRepair and car operation |
|
Mercedes W202 - 1.2. The general data 1.3. Maintenance service 1.4. Keys 1.5. Doors 1.6. Seats + 1.7. Safety systems + 1.8. The salon equipment - 1.9. Driving 1.9.2. Трогание about places and a gear change 1.9.3. Installation of the lever of a choice (DB) 1.9.4. The switch of a choice of a mode movements (DB) 1.9.5. Traffic control 1.9.6. Cruise-control 1.9.7. The oil and fuel expense 1.10. An engine cowl 1.11. The ventilation block, the conditioner 1.12. Some councils at car purchase 1.13. Changed numbers 1.14. Purchase of the old car 1.15. Durability of the car 1.16. About parallelism of bridges of the car and the trailer + 1.17. Preparation of the car for winter + 2. Maintenance service + 3. Engines + 4. Greasing system + 5. Cooling system + 6. Heating, ventilation + 7. Ignition system + 8. Fuel system + 9. Transmission + 10. A running gear + 11. A steering + 12. Brake system + 13. A body + 14. An electric equipment + 14.2. Electroschemes |
1.9.2. Трогание about places and a gear change
Having got under way from a place check up a brake. Quickly warm up the engine. After achievement of the necessary temperature of the engine check up a steering. In order to avoid damage of a back axis, at трогании from a place on a slippery surface of road completely avoid long прокручивания driving wheels. Mechanical transmission Switching on a reverse gear is carried out at the standing car. For this purpose it is necessary to raise the switching lever. Do not exceed as much as possible admissible speeds in separate transfers (see marks a speedometer). The prevention Automatic transmission Separate transfers join automatically, depending on: – Lever positions; The prevention Трогание Establish the choice lever on desirable position only in a single mode of the engine, задействуя thus a braking mode. At once at трогании release a brake, differently there is a danger that the car will get under way prematurely. Installation of a pedal of an accelerator It is not enough gas = earlier operation = insignificant dispersal. It is a lot of gas = later operation = strong dispersal. It is too much gas (the accelerator pedal is drowned below a point of full gas) = return switching on lower transfer = the maximum dispersal. |
|