Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
- 1.2. The general data
   1.3. Maintenance service
   1.4. Keys
   1.5. Doors
   1.6. Seats
   + 1.7. Safety systems
   + 1.8. The salon equipment
   + 1.9. Driving
   1.10. An engine cowl
   1.11. The ventilation block, the conditioner
   1.12. Some councils at car purchase
   1.13. Changed numbers
   1.14. Purchase of the old car
   1.15. Durability of the car
   1.16. About parallelism of bridges of the car and the trailer
   + 1.17. Preparation of the car for winter
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes











1.6. Seats
THE GENERAL DATA


Change of position of a forward seat

On length: the Handle (1) to lift upwards, a seat to move forward or back, the handle (1) to fix.

Inclination of a pillow for sitting: to Rotate a wheel (2) forward or back.


Seat height: to lift a regulator (3).

Sitting to move forward = to establish above.

Seat to move back = to establish more low.

Regulator to fix.

Back inclination: the Wheel (4) forward or to rotate before the necessary position back.

Seat headrest: for installation on height slightly to press it forward. To establish a headrest so that a nape it was propped up approximately at level of ears. Thus it is impossible to pull out a headrest further emphasis positions.

Electric adjustments of position of a forward seat


Switches are in forward doors.

Key in the steering lock in position 1 or 2 (at an open lobby of a door, and also at the taken out key or position of a key "0").

Seat and headrest installation:

A.Izmenenie of position of a pillow of a seat.

V.Izmenenie of position of a back of a seat.

S.Izmenenie of headrest position.

Establish a headrest so that the nape was propped up approximately at level of ears. The headrest can be regulated also manually forward.


The prevention

Do not pull out a headrest a hand further emphasis position.



Input and storing of position of a seat and headrest:

D. The input and storing button.

E. Buttons of a position "1" and "2".

2 positions can be entered, after seat and headrest installation to press the input and storing D button, to release it and within 3 seconds to press the item button 1.

By means of the item button 2 one more installation of positions of a seat and a headrest can be entered and kept.

Call of positions of a seat stored in memory and a headrest:

At occurrence of necessity for installation of desirable positions of a seat and a headrest, press the corresponding item button until there will be a desirable installation. If the item button to release, from reasons of safety installation process will interrupt at once.

Orthopedic back of a seat


For maintenance of correct position of a backbone in a seat back there are air cushions. Position and a pressure force of a back of sitting are established at position 2 locks of a steering.

Regulate the step switch (1) pressure in air cushions (from "0" = without pressure to 4 – the maximum pressure).

Positions of a back of a seat are established by the switch (2) from position "And" – the lowest to "Е" – the highest.

After the trip termination last chosen position is established automatically anew.

Seat heating

Key in the steering lock in position 2.

To include: to Press 1 = a normal mode of heating. In the switch the control bulb burns

To press 2 = fast heating. In the switch both control bulbs burn.

After approximately 5 minutes seat heating will be switched automatically to a normal operating mode and in the switch one control bulb will burn only.

To include: If in the switch one control bulb burns, to press 1.

If in the switch 2 control bulbs burn to press 2.

Automatic switching-off of heating of a seat will occur approximately in 30 minutes.


The prevention

Heating of a seat demands an energy considerable quantity, therefore do not hold this mode included more than it is necessary.


If many consumers of energy or the accumulator are included is insufficiently charged, seat heating can automatically be disconnected. In this case the control bulb blinks (at fast heating both bulbs) blink. As soon as demanded pressure appears again, seat heating joins automatically.

If blinking of control bulbs disturbs, you can switch off heating of a seat by the switch.

Armrest of a forward seat


Position 1 – the armrest is lifted.

Position 2 – at normal position of a back of a seat.

Position 3 – at strongly inclined position of a back of a seat.

For armrest lowering press the button (4).


The prevention

The armrest does not replace system of support for children. At face-to-face blow or collision of the child can rush forth through the stopped armrests. They are used only for protection from соскальзывания at braking.


Armrest of a back seat

To pull out armrests for a loop.

Headrests of a back seat

To establish headrests of a back seat so that a nape it was propped up approximately on a line of ears.