Mercedes S-class W202

1993-2000 of release

Repair and car operation

Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
- 14. An electric equipment
   14.1.2. Measuring devices
   14.1.3. Technics of measurements
   14.1.4. Electric equipment checks
   14.1.5. A sound signal
   14.1.6. Replacements of safety locks
   + 14.1.7. The storage battery
   + 14.1.8. The generator
   + 14.1.9. A starter
   14.1.10. The traction relay
   + 14.1.11. Illumination system
   14.1.12. Devices
   14.1.13. The instrument panel
   14.1.14. Lamps накаливания on the panel of devices
   14.1.15. Light switch
   14.1.16. A radio receiver
   + 14.1.17. The aerial
   14.1.18. Dynamics
   - 14.1.19. Rubber brushes of screen wipers Diagnostics of malfunctions of brushes of screen wipers
   14.1.20. Jets стеклоомывателя
   14.1.21. Washing atomizers of headlights
   14.1.22. A screen wiper and its engine
   14.1.23. Protect the car
   14.1.24. Anticreeping "immunodeficiency"
   14.1.25. Why headlights grow dull
   14.1.26. "Галогенки"
+ 14.2. Electroschemes Diagnostics of malfunctions of brushes of screen wipers

Brushes slip
The rubber brush is polluted Clear a rubber brush a rigid nylon brush and a solution of a washing-up liquid or spirit.
Обтрепавшиеся протирочные lips, rubber выкрошилась or has worn out Replace a rubber brush.
Rubber has undergone to ageing, a surface with cracks Replace a rubber brush.
In a zone of clearing the water rests roll down at once in drops
The windscreen is polluted политурным by a varnish or oil Clean a windscreen a pure rag and a silicone spot remover.
The screen wiper brush well clears in one party, in another – it is bad
The rubber brush on the one hand is deformed, "does not overturn" any more Insert a new rubber brush.
The lever of a brush of a screen wiper is overwound Cautiously unscrew the lever of a brush of a screen wiper in the opposite direction until normal vertical position will be reached.
Surfaces are not cleared
The rubber brush has jumped out of a frame Cautiously insert a brush into a frame.
The screen wiper brush does not adjoin any more in regular intervals to glass as are bent spring directing or guards Replace a screen wiper brush.
Too low pressure of a clip because of the lever of a brush of a screen wiper This defect is observed first of all when the spare brush is incorrectly established. Slightly oil the hinge of the lever of a brush of a screen wiper and a spring or establish the new lever.