Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
+ 12. Brake system
+ 13. A body
- 14. An electric equipment
   14.1.2. Measuring devices
   14.1.3. Technics of measurements
   14.1.4. Electric equipment checks
   14.1.5. A sound signal
   14.1.6. Replacements of safety locks
   + 14.1.7. The storage battery
   + 14.1.8. The generator
   + 14.1.9. A starter
   14.1.10. The traction relay
   - 14.1.11. Illumination system
      14.1.11.1. Lamps of near, distant and antifog light
      14.1.11.2. A lamp in a forward lantern of the index of turn
      14.1.11.3. A lamp in a back lantern
      14.1.11.4. A lamp in a lantern of illumination of licence plate
      14.1.11.5. A plafond in salon
      14.1.11.6. A lantern of the index of turn
      + 14.1.11.7. A headlight
      14.1.11.8. A back lantern
   14.1.12. Devices
   14.1.13. The instrument panel
   14.1.14. Lamps накаливания on the panel of devices
   14.1.15. Light switch
   14.1.16. A radio receiver
   + 14.1.17. The aerial
   14.1.18. Dynamics
   + 14.1.19. Rubber brushes of screen wipers
   14.1.20. Jets стеклоомывателя
   14.1.21. Washing atomizers of headlights
   14.1.22. A screen wiper and its engine
   14.1.23. Protect the car
   14.1.24. Anticreeping "immunodeficiency"
   14.1.25. Why headlights grow dull
   14.1.26. "Галогенки"
+ 14.2. Electroschemes







14.1.11.8. A back lantern

Removal

PERFORMANCE ORDER
1. Take a floor covering from a luggage carrier.
2. Dismantle an internal upholstery around a back lantern.
3. Remove штеккерный I will corrode below on the lamp holder.

Installation

40. A shtekkernyj socket
41. The lamp holder
42. Nuts
43. A reflector
44. Lantern glass
45. Consolidation

PERFORMANCE ORDER
1. Check up consolidation on absence of porosity and damages, if necessary replace it.
2. Insert glass of a back lantern together with consolidation outside into a body.
3. Press a reflector and in regular intervals hardly tighten fixing nuts.
4. Insert the lamp holder and fix it, rotating to the right the plastic handle.
5. Spread штеккер on a socket.
6. Mount an internal upholstery.
7. Turn horizontally plastic handle on a back lantern and remove the lamp holder.
8. Unscrew fixing nuts (42).
9. Take outside glass of a back lantern (44) together with consolidation (43), a reflector remove inside.