Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
+ 11. A steering
- 12. Brake system
   12.2. Antiblocking system – ABS
   12.3. The additional equipment – system ASR
   12.4. Specifications of brake system
   12.5. Overlays of lobbies brake колодок
   + 12.6. Overlays of back disk brakes
   12.7. A support
   12.8. A forward brake disk
   12.9. A back brake disk
   12.10. A brake liquid
   12.11. Removal of air from brake system
   12.12. Brake pipelines / hoses
   12.13. Replacement of brake highways
   12.14. Brake колодки a lay brake
   12.15. Adjustment of a lay brake
   12.16. The stoplight switch
   12.17. Diagnostics of malfunctions of brakes
   + 12.18. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes







12.9. A back brake disk Removal

PERFORMANCE ORDER
1. Unscrew a support of a back wheel and suspend on a self-made wire hook that the brake hose did not break draught.
The prevention

Not to disconnect a brake hose, differently it is necessary to delete air from brake system.


2. Unscrew a wrench with internal шестигранником a bolt of fastening (64) and remove a brake disk (62) from a flange of a shaft of a back axis (68), (70) adjusting pin.

The prevention

The lay brake should be completely released. Rigidly sitting brake disk to separate easy blows of a plastic hammer.


Installation

PERFORMANCE ORDER
1. That uniform braking from both parties was provided, both brake disks should have equally ground surface and identical depth of microroughnesses on it. Check up a thickness of brake disks and their lateral palpation.
2. If there is a rust on a flange of a brake disk and a shaft of the back bridge remove it. Cover landing of a flange of a shaft of the back bridge by a thin layer of high-temperature greasing, for example, Molykote-Paste "U", Molykote-Paste G Rapid, Liqui-Moly-Paste 36.
3. Clear a new brake disk of a protective varnish a nitrothinner. Instead it is possible to clear and degrease also brake disks steam stream under a high pressure.
4. If the old brake disk is mounted, clear and visually check up a surface of frictional overlays for a lay brake. Check up mobility распорного the lock brake колодок a lay brake.
5. So establish a brake disk on a flange of a shaft of a back axis that the adjusting pin has entered into a brake disk. Screw up a new bolt of fastening and tighten with the moment 10 Н.м.
6. Establish a support.