Mercedes S-class W202

1993-2000 of release

Repair and car operation

Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
- 11. A steering
   11.2. The block of an inflatable pillow of safety on a steering wheel
   11.3. A steering wheel
   11.4. A steering trapeze
   11.5. Cuffs of hinges of a steering trapeze
   11.6. The pump of the hydraulic booster of a wheel
   11.7. Disorder-convergence installation
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes

11.4. A steering trapeze

Steering draught and levers of a steering trapeze are connected with each other by means of ball hinges and do not understand.


1. Designate a paint position of forward wheels in relation to a nave. Thanks to it the removed wheel can be put on that place in which it was before. Release wheel bolts on the car standing on the earth, then put it on supports, unscrew bolts completely and remove forward wheels.
2. Unscrew the steering shock-absorber (46) from steering draught (11). Unscrew fixing nuts of hinges of the pendular lever (26) from сошки the steering mechanism (23) and on rotary fists. Thus keep pins of hinges a key with internal шестигранником SW 5.
3. Remove hinges of a steering trapeze by means of a stripper 050 or HAZET 779.

The prevention

Do not damage rubber cuffs.


1. Move hinges for pins. At the raised ease of a course or if is available люфт, replace a tip of the lever of a steering trapeze.
The prevention

The left hinge of a trapeze is intended only for turns (does not bend).

2. Check up пыльники about damage and негерметичность (выступание greasing containing in them). If пыльники are damaged, replace a draught tip, accordingly, draught since the dirt which has got inside puts out of action the hinge in a short space of time.
The prevention

If the cuff is damaged only at removal enough to replace a cuff.


1. Clear of greasing of a pin of hinges of a trapeze, and also seats in operating levers.
2. Densely insert pins of hinges into cones of corresponding levers.
3. Wrap new самоконтрящиеся nuts, keeping a pin a key with internal шестигранником, and tighten nuts the moment 50 Н.м.
4. Screw the steering shock-absorber by means of new самоконтрящейся nuts, tightening it with the moment 35 Н.м. To steering draught.
5. Put forward wheels so that at removal the put marks have coincided. Screw wheels. Remove the car from supports and tighten bolts of fastening of wheels with the moment 110 Н.м. In a crosswise order.
6. Check up a convergence.
The prevention

For safety before the trip beginning be once again convinced that on all hinges of draughts are put new самоконтрящиеся nuts and they are tightened with the correct moment.