Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
- 11. A steering
   11.2. The block of an inflatable pillow of safety on a steering wheel
   11.3. A steering wheel
   11.4. A steering trapeze
   11.5. Cuffs of hinges of a steering trapeze
   11.6. The pump of the hydraulic booster of a wheel
   11.7. Disorder-convergence installation
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes











11.3. A steering wheel Removal

PERFORMANCE ORDER
1. Remove the block of an inflatable pillow of safety.
The prevention

Observe instructions under the reference with it.


2. Having unblocked the wheel lock, put wheels directly.
3. Block a wheel, having turned a few steering wheel, latch the lock.
4. For an adjustable column: completely drown a steering wheel.
5. Unscrew a bolt with a secret head (32с) a face key-shestigrannikom. Not to damage thus the wheel lock, the assistant should keep a steering wheel. Disconnect штеккерные connections (38b) and (38с).
6. Remove a steering wheel from a shaft, if necessary bring down its palm. Position of a steering wheel concerning a shaft has serial marks.

Installation

PERFORMANCE ORDER
1. Pass штеккеры (38b) and (38с) through apertures in a steering wheel.
2. Spread a steering wheel so that shaft and wheel marks have coincided.
3. Screw in new самоконтрящийся a bolt with a secret head and tighten it with the moment 80 Н.м., thus the assistant should keep a steering wheel.
4. Put the block of an inflatable pillow of safety.
5. Make a trial trip and at movement on a straight line check up steering wheel position. The cross-beam upper edge should stand horizontally.
6. In the event that there is an inclination, it is possible to displace on one tooth a nozzle on шлицы a steering shaft.
The prevention

If it is not enough this displacement of a steering wheel, check up a convergence of forward wheels.


7. Track the control indicator of the block of an inflatable pillow of safety at full turn of a steering wheel against the stop in both directions at the working engine, the control radiator should not light up.
8. Check up a blinking light and switching-off of the index of turn after turn.
The prevention

The dirty or sticky steering wheel can be cleared by means of a neutral household cleaner and slightly warm water. Do not apply at clearing of a wheel of abrasive powders or pastes.