Mercedes S-class W202

1993-2000 of release

Repair and car operation



Mercedes W202
+ 1.2. The general data
+ 2. Maintenance service
+ 3. Engines
+ 4. Greasing system
+ 5. Cooling system
+ 6. Heating, ventilation
+ 7. Ignition system
+ 8. Fuel system
+ 9. Transmission
+ 10. A running gear
- 11. A steering
   11.2. The block of an inflatable pillow of safety on a steering wheel
   11.3. A steering wheel
   11.4. A steering trapeze
   11.5. Cuffs of hinges of a steering trapeze
   11.6. The pump of the hydraulic booster of a wheel
   11.7. Disorder-convergence installation
   11.8. Easily and easy
   11.9. Maintenance service of system of a steering
   11.10. Diagnostics of malfunctions of system of a steering
+ 12. Brake system
+ 13. A body
+ 14. An electric equipment
+ 14.2. Electroschemes






11. A steering

11.1. Introduction
THE GENERAL DATA

Noncontrollable steering column

1. The steering mechanism
2а. A bolt, 25 Н m.
71b. Nuts, 8 Н m.
71c. A sealing cuff
93. A casing
3. The bottom steering shaft
А45. A contact payment
S4. The combined switch
S40. The push-button switch темпомата

Steering draughts

11. A steering trapeze
11f. Hinges of steering draught
11a. Ball hinges
10g. Tips of levers of a steering trapeze

The steering consists of a steering wheel, a steering shaft, the steering mechanism, steering draught, the steering shock-absorber and the wheel hydraulic booster. The steering wheel is screwed on a steering shaft which transfers wheel rotation to the steering mechanism.

Depending on wheel position transfer to the steering mechanism changes. It means that than turn of a wheel more, especially indirect there is a transfer. The steering wheel thus, for example, at a parking, turns easier. Direct transfer on the average position provides the raised accuracy of management, in particular on high speeds.

The hydraulic booster provides small effort to a steering wheel. It consists of the pump, the tank and tubes. The pump soaks up oil for hydraulics from the tank and submits it under pressure to the steering mechanism where the regulating device and the working cylinder provide corresponding strengthening.

As the additional equipment the mechanical regulator of length of a steering column for steering wheel installation can be put.

While the inflatable pillow of safety for the driver is built in a steering wheel, the pillow for the passenger is on the right on the forward panel. At strong front blow works пиропатрон, and pillows are inflated for thousand fractions of a second. It is enough this time to soften front blow for people. For few seconds after operation the pillow is blown off, as gases leave through apertures in it. The inflatable pillow for the passenger is put as the additional equipment.

The firm recommends to replace an inflatable pillow after ten years' operation of the car to guarantee its work.


The prevention

Самоконтрящиеся nuts are replaced always. Welding and рихтовочные works on a steering are inadmissible. At an experience lack, and also the big repairs it is necessary to address in a workshop.


Instructions under the reference with an inflatable pillow of safety

The device cannot be assorted, at malfunction all is replaced in gathering. As the block contains explosives, store it under the lock or under supervision. Recycling is made by firm workshops.

After dismantling the block hold the soft party upwards.

The pillow block cannot be wiped water or cleaners.

Do not overheat the block above 100 ° With.

The block of a pillow of safety is sensitive to blows. If it fell from height of 50 sm it already cannot be put on the car.

The block of a pillow of safety is authorised to be removed only at the disconnected plug of weight of the accumulator (–) and in position "About" of the ignition key.